Helpful Information About Submersible Well Pumps

11 January 2017
 Categories: , Blog


Have you noticed that the water pressure level from your plumbing fixtures is drastically lower than it once was? If your water supply comes from a well, the root cause of the problem can stem from a few areas. For instance, there are several parts to a submersible well pump that must be in good shape in order for you to receive a sufficient amount of water in your house. Below, you will find information that can help you get to the bottom of the problem of low water pressure coming out of plumbing fixtures.

1. The Submersible Well Pump Is No Longer Powerful

If the water pressure is low inside of your house, it might be due to the submersible well pump not having enough power to operate as it should. The pump might work, but only in a very mild manner. It is possible that the lack of power stems from a small amount of electricity powering the pump up. An electrical problem can stem from pump wires being frayed, rusty, and in need of being replaced. You might also need to replace the electrical panel in your house if it has become worn out.

2. You Need to Get the Motor Repaired

The motor is the main part that the pump must have in order to do its job. If the motor has not been as loud as it normally is, the problem might be due to it being in a bad condition. A contractor might only need to remove dirt or oil that has accumulated on the pump to make it work to the fullest extent. If the motor is simply in a condition that is beyond repair, it can easily be replaced by a contractor. You can actually invest in a used motor if you need to stay within a small budget.

3. Mechanical Seals Are Not as Tight as They Should Be

The reason for the low level of water pressure can stem from mechanical seals being loose. Keep in mind that the seals are an important part of the pump because they prevent water from leaking out. For instance, there is a rotating and stationary area on the shaft of a well pump that transports water. The seals are located in those areas to make sure water remains in place as it is being moved to the discharge lines. A contractor will only have to tighten the seals to get rid of the problem.


Share